lines installed crossmember in place.
Viewed: 3 times.
|
|
|
floor board bellhousing TC case brace clearance.
Viewed: 1 time.
|
|
|
3/8-1/2" clearance, bellhousing to firewall.
Viewed: 1 time.
|
should be enough room behind heads for wiring ect, engine in stock location so propshaft and driveshaft fit. with the intake off I could reach all the bellhousing bolts except the bottom ones, from the firewall side!
|
Oil cooler lines, filter under DS between rocker panel and frame, cooler under rear floor board DS. I did raise the DS motor mount with 1/4" spacer to get a little more diff' clearsnce.
Viewed: 3 times.
|
lines running behind innerfender to filter under DS door.
|
filter is between frame and rocker pannel
|
engine oil cooler, check the driveline angle.excessive driveline angle losses HP and breaks things.
|
|
drive line angle, no problem. now I have to get a drive shaft loop in there.
Viewed: 2 times.
|
1'4- 3/8 clearance between dust cover and front propshaft.
Viewed: 1 time.
|
|
ground off the fins on the dust cover to make room for the propshaft
|
